8 mm Low Profile Pellet Press Die Set custom 6 mm die sets require

6 mm die sets require relatively small loads to apply huge stresses so always make sure you stay safe and stay below the max loading force of the pellet die set

31 kN) Typical force for quality pellets 875-2650 lb (0

The 6mm (1/4 inch) Pellet Dies require a relatively small amount of material to make a pellet compared to the larger diameter dies

Pressure range  0 -25T (0 - 34 MPa) Pressure gauge Gauge displays force in both Tons and MPa units for versatility Protection Cover Polycarbonate Safety Shield is used with the press to protect the user from fragmentation

please complete the custom die set form

8 mm Low Profile Pellet Press Die Set custom 6 mm die sets requireThis low profile die set is an 8 mm (0. 3 inch), short length <6 mm (<0. 2 inch) pellets. The compact design and high strength heat treated stainless steel means a higher force can be applied while pressing reducing the chance of plunger breakages. Features of this die set are: Compact Design: Built for High Loads High Strength Stainless Steel: Heat treated to 160,000 psi Built in ejector sleeve Heatable up to 250C (482F) Low profile pellet press die